Belair® 2.0 - 6" Textured Retaining / Freestanding Wall - Belgard

• Can be used for straight or curved walls
• Freestanding walls can be built up to 3 feet high, including buried course, but excluding the cap
• Gravity walls can be built up to 3 feet high, including buried course, but excluding the cap*
• Taller walls can be built using geosynthetic reinforcement when designed by a qualified engineer
• Rear-lip on retaining wall block makes installation fast and accurate
• Coordinating cap and end units complete the system

• FreeStanding Walls (FSW): Minimum radius using all three units: 4 feet
• Segmental Retaining Walls (SRW): Setback/System batter: 1"/9.5º
• Minimum outside radius, measured on the top course to the front of the units: 4 feet
• Minimum inside radius, measured on the base course to the front of the units: 8 feet
  **This height assumes level backfill and clean, compacted sand or gravel and no surcharge.
  **Product dimensions are height by face length by depth. Actual dimensions may vary from these approximate values due to variations in manufacturing processes.

Each Belgard Wall is made by various Belgard manufacturing plants across the country. Each manufacturing plant has their own specific capabilities and capacities, and the amount of square footage and weight by pallet can be different by plant. The below table contains the square foot and weight by pallet/cube, by each manufacturing plant. If you are ordering, this information is important for determining the right order quantity and correct shipping cost.