Tint Seal Color Rejuvenating Pigmented Sealer - Acrylux

For years, Acrylux's team has been looking for a solution to paver color renewal. The film-forming characteristic of these compounds, whether two-part water base, xylene base, or one-component water base, generated a finished result that appeared overly "painted" or "stained." The ability of Tint-Seal to permeate the paver and carry the required tones with it modifies the color of the paver without damaging the natural appearance of the paver.

Tint Seal is a one-part urethane base and UV-Resistant tint system that allows you to restore color to pavers that have lost their color! This paver sealer allows you to bring life back to your pavers without them looking painted or stained.

• Check the surface of the pavers for any existing sealer. If the surface contains an existing sealer, strip with ColorBack Horizontal Hard Surface Stripper.
• Clean the surface using standard paver cleaning practices.
• Allow pavers to become surface dry before applying Tint-Seal. Do not apply Tint-Seal to a wet or damp surface for the best results. Dry times vary depending on air temperature, wind, and humidity.
• Mix the dedicated tint package in the sealer for two (2) minutes directly before use. Stir occasionally to ensure color uniformity.
• We recommend applying Tint-Seal with an airless sprayer to achieve the best results. Recommended tip size: .013 - .015. Recommended pressure: Low - Medium. If a pump sprayer is being used, ensure that it reaches full atomization to prevent puddling or over-application. It is important that the machine can produce an even, consistent fan and complete full courses.
• Begin at the top or bottom of the desired area and spray full courses from one side to the other achieving a 50% wet-on-wet overlap on each pass. If you must stop spraying before covering the entire area, stop on a joint line.
• If additional color is desired. Apply a second coat after 30 minutes.

Recommended Alternatives :

ColorBack WC Semi-Gloss	Luxstone Impregnator NL